Brocade Fabric OS Encryption Administrator's Guide Supporting Fabric OS v6.2.0 (53-1001201-04, May 2009)

Encryption Administrator’s Guide 65
53-1001201-04
Adding encryption targets
2
a. Select a target from the list. (The Target Port WWN and Target Node WWN fields contain all
the target information that displays using the nsshow command.) You can also enter
WWNs manually if you prefer, or if you want to specify a target that is not on the list.
b. Select a Target Type. Disk is selected and cannot be changed. If the target node is disk
storage, choose Disk. If the target port is tape storage, choose Tape.
7. Cli ck Next.
The Select Hosts panel displays. This panel lists all hosts in the same fabric as the encryption
engine. There are two available methods for selecting hosts: select from a list of known hosts
or manually enter the port and node world wide names.
FIGURE 52 Select Hosts dialog box
a. Select a maximum of 1024 hosts from the Host Ports in Fabric list, and click the right
arrow to move the host to the Selected Hosts list. (The Host Port WWN column contains all
the target information that displays using the nsshow command.)
b. Manually enter world wide names in the Host Port WWN and Host Port WWN text boxes, if
the hosts are not included in the list. You must fill in both the Host Port WWN and the Host
Node WWN. Click the Add to Selected Hosts button to move the host to the Selected Hosts
list.
8. Click Next when you are finished selecting hosts or manually entering the WWNs.
The Name Container panel displays.
The name container step in the wizard enables you to specify a name for the target container
that is created in the encryption engine to hold the target configuration data.
9. The container name defaults to the target WWPN. You can, however, rename the container
name. If you want to specify a name other than the default, enter a name, using a maximum
number of 31 characters. Letters, digits, and underscores are allowed.