Brocade Fabric OS Encryption Administrator's Guide Supporting Fabric OS v6.2.0 (53-1001201-04, May 2009)

Encryption Administrator’s Guide 35
53-1001201-04
Configure Encryption for RKM key vaults
2
6. Enter an Encryption Group Name for the encryption group (the maximum length of the group
name is 15 characters; letters, digits, and underscores are allowed) and select the Automatic
failback mode.
NOTE
If the name you enter for the encryption group already exists, a pop-up warning message
displays. Although unique group names avoid confusion while managing multiple groups, you
are not prevented from using duplicate group names. Click Yes to use the same name for the
new encryption group, or click No to enter a new, unique name.
7. Cli ck Next.
The Select Key Vault dialog box displays.
FIGURE 20 Select Key Vault dialog box
a. Select the RSA Key Vault Type.
b. Enter the IP address or host name for the primary key vault.
When a new key vault IP address or host name is entered, you must also enter the name of
the file that holds the primary key vault’s public key certificate (or browse to the location by
clicking the Browse button).
c. Enter the name of the file holding the primary key vault’s public key certificate.
If you are using a backup key vault, also enter the IP address or host name, and the name
of the file holding the backup key vault’s public key certificate in the fields provided.
See the notes in “Key vault address changes” on page 41 before you add, change, or
remove key vaults.
8. Click Next.
The Specify Public Key Certificate Filename panel displays.