Brocade Fabric OS Encryption Administrator's Guide Supporting Fabric OS v6.2.0 (53-1001201-04, May 2009)

Encryption Administrator’s Guide 207

53-1001201-04

General encryption troubleshooting using the CLI

“Temporarily out of resources” message received during

re-key or first time encryption.

Re-key or first time encryption sessions are pending due to resource

unavailability. A maximum of twelve sessions including rekey (manual or auto)

and first time encryption sessions are supported per encryption switch or

blade and two sessions per target. The system checks once every hour to

determine, if there are any re-key or first time encryption sessions pending. If

resources are available, the next session in the queue is processed. There

may be up to an hour lag before the next session in the queue is processed. It

is therefore recommended that you do not schedule more than 12 re-key or

first time encryption sessions.

HA cluster creation fails with error, "Create HA cluster

status: The IO link IP address of the EE (online) is not

configured”, even though both the addresses are set and

accessible.

The IP addresses for the I/O link ports should be configured before enabling

the EE. Failure to do so results in unsuccessful HA Cluster creation. If the IP

addresses for these ports were configured after the EE is enabled, reboot the

encryption switch or slotpoweroff/slotpoweron the encryption blade to sync

up the IP address information to the EE.

Re-keying fails with error “Disabled (Key not in sync)”. Re-keying was started on a remote EE but the local EE is not capable of

starting re-key because the key returned from key vault does not match with

the Key ID used by remote EE. You will need to re-enable the LUN after the

keys are synced between two key vaults properly using the needs to cryptocfg

--discoverLUN <Container Name> command.

cryptocfg --commit fails with message “Default zone set

to all access at one of nodes in EG.”

Default zoning must be set to no access. Refer to “Setting default zoning to no

access” on page 95.

TABLE 16 General errors related to using the CLI (Continued)

Problem Resolution