HP StorageWorks Enterprise Modular Library E-Series User Guide (AH876-96001, September 2007)

5 Moving the library
This section explains how to move or ship the library. To s hip the library, or move it using a motor
vehicle(forexample,truck,orforklift),followtheinstructionsinthissection. Tomovethelibrarytoa
new location within the same building or facility, follow all instructions in this section except for those
found in “Repacking the library” on page 100.
NOTE:
These procedures require the original packaging materials of the library . If you do not have the original
packaging materials, contact your support representative for ordering information.
CAUTION:
Moving or shipping the library without proper p ackaging materials can result in damage to library
components. HP strongly recommends that an HP authorized service representative move a library to
another location.
Selecting an installation location
When choosing a n installation site for the library, consider the requirements in the following sections.
Preparing the library for a short move
1. Remove a ll tape cartridges from the tape d rives using your application software.
2. At a minimu
m, attach the robot shipping straps.
11666
2
1
1
Shipping straps
2
Yellow gear lock
3. For ad
ded protection, also push the yellow gear lock up to prevent movement of the reduction g ear.
4. Roll t
he library carefully on level surfaces to its destination.
Enterprise Modular Library E-Series
99