HP StorageWorks Enterprise Modular Library E-Series User Guide (AH876-96001, September 2007)

10466
Figure 51 Sc
rew locations on the base-module power supply
WARNING!
The power su
pply might be hot.
5. Pull the handle on the power supply to remove it from the library.
6. The bracket is not part of the replacement kit. You must move the bracket from the original p ower
supply to the new power supply. Remove the two 6-32 x 1/4-inch Torx screws that attach the bracket
to the power supply with a T-15 Torx screwdriver.
10467
Figure 52 Removing the base-module power supply bracket
Replacing a power supply in the base module or tape drive expansion module
1. Attach the bracket to the new power supply with two 6-32 x 1/4 -inch Torx screws. Use a T-15
T orx screwdriver.
2. Slide the power supply into the library.
3. Attachthepowersupplytothelibrarywithtwo6-32x3/8-inchTorxscrews.
90
Removing and replacing parts