HP StorageWorks Enterprise Modular Library E-Series User Guide (AH876-96001, September 2007)

3. Tighten the captive screws in both ejector handles. Use a #1 Phillips screwdriver.

4. Plug the cables into the Interface Manager card exactly as they were plugged into the original

Interface Manager card (see the labels on the c ables or the note that you wrote) .

5. Turn on the p ower to the library.

NOTE:

Becausealloftheconﬁguration settings for the Interface Man ager card are stored on the

CompactFlash memory card that you moved, your new Interface Manager card retains

the conﬁguration of the original card. To examine or change these settings, see the

StorageWorks Interface Manager a nd Command View TL user g u ide

6. Make sure that the status LEDs indicate a normal state (see

“HP StorageWorks Inter face Manager c ard” on page 56).

CompactFlash memory card

Part Number

342215-001

Location

On the Interface Manager card

Characteristics CompactFlash memory card in a holder

Function

Stores the ﬁrmware and conﬁguration settings for the Interface

Manager card

Illustration

To replace the CompactFlash memory card, see step 9 on page 84 of the Interface Mana ger card

removal procedure.

HP StorageWorks e2400-FC 2Gb interface controller

Part number

356690-001 or 416274-001

Location

Inthemiddleslotinthebase-modulecardcageorinanyslotin

the card cage expansion module

Characteristics

Contains two HBA or switch FC por ts, four tape drive FC ports,

one Ethernet port, and one serial port

Function

Manages up to four tape drives and provides bidirectional

connectivity for 2 Gbps FC interfaces

Illustration

10464

Required tools

• #1 Phillips screwdriver

Removing an e2400-FC 2Gb inter face controller

1. Identify the e2400-FC 2 Gb interface controller to be replaced by one of the following methods:

Enterprise Modular Library E-Series