HP StorageWorks Enterprise Modular Library E-Series User Guide (AH876-96001, September 2007)

10483
Figure 47 Removing the Interface Manager card
9. Move the CompactFlash memory card from the original Interface Manager c ard to the new Interface
Manager ca rd. The CompactFlash m em ory card stores the firmware and configuration information
for the Interface Manager card.
a. Put the Interface M anager card battery-side up on your work surface.
b. Grasp the edges of the CompactFlash memory card and slide it out of the flash memory
slot. If needed, push a pen into the corner notches of the flash memory slot to disengage
the CompactFlash mem ory ca rd.
gl10032
1
2
3
1
Interface Manager card
3
CompactFlash memory card
2
Flash memory slot
Figure 48 Removing t h e C om pactFlash memor y card from t he Inter face
Manager card
c. Put the new Interface Manager card battery-side up on your work surface.
d. With the connector going in first, align the sides of the CompactFlash memory card with the
flash memory slot on the new Interface Manager card. Gently slide the CompactFlash memory
card into the slot until it is fully engaged. If the CompactFlash memory card does not slide
in easily, the card is upside down.
Replacing the Interface M anager card
1.
Orient the Interface Manager card as s hown in Figure 4 7 on page 84. Align the Interface M ana ger
card with the guides in the bottom slot in the card cage in the base module and slide the Interface
Manager card into the library.
2. Push the ejector handles to the inside to fully engage the Interface M anager card into the backplane.
84
Removing and replacing parts