HP StorageWorks Enterprise Modular Library E-Series User Guide (AH876-96001, September 2007)

c. Roll the library onto the p allet.
2. Secure the library:
a. Place the antistatic ba g over the library, and secure it into place.
b. Use the four shipping bolts to secure the library to the pallet.
c. Remove the ramps from the pallet and place them in a box.
3. Place the ramp box and accessory kits onto the pallet.
4. Place the four corner posts against the rack.
5. Wrap the cardboard sheets around the library, and fasten using the plastic restraining clips.
6. Place the top (cap) onto the pa cked library.
7. Secure the packed library with two restraining bands.
2
gl01013
6
1
2
2
2
2
3
4
5
6
3
1Ramps
4
Cap
2Cornerposts
5
Antistatic bag
3
Corrugated sheets
6
Shock pall et
Figure 57 Repacking the library
Preparing the library for operation
After s hipping o r moving the library, see the Getting Started manualforyourlibraryto:
• Prepare the new installation site.
• Rece
ive the library .
• Uncrate the library.
• Position the library.
• Remo
ve the robotics unit shipping restraints.
• Install and configure the library.
Enterprise Modular Library E-Series
101