HP StorageWorks Enterprise Modular Library E-Series user guide (AH876-96001, October 2007)

Figure 53 Removing a pow er supply from a card cage expansion module

Replacing a power supply in the card cage expansion module

Orient the

power supply as shown in Figure 53 on page 92. Align the power supply with the guides

in the card cage and slide the power supply into the library.

2. Push the ejector handle to the right.

3. Tighten t

he two captive screws. Use a #2 Phillips screwdriver.

LTO2 or LTO3 tape drive

Part number 3 7 5817-001 or 409859-001 (Ultrium 460 or L TO2)

381676-0 01 or 409860-001 (Ultrium 960 or LTO3)

Location

In the base module or tape drive expansion module

Characteristics

• Hot-swappable

• 1/2-inch cartridge tape drive

Function

Writes

data to and reads data from Linear Tape-Open (LTO)

cartr

idges

Illustration

gl01014

Req

uired tools

• Flat-blade screwdriver

Removing an LTO2 or LTO3 tape drive

1. Identify the tape drive to be replaced. The FAULT LED light might be lit (see

“HP StorageWorks Ultrium tape drives”onpage58).

Removing and replacing parts