HP StorageWorks Enterprise Modular Library E-Series user guide (AH876-96001, October 2007)

Function Description
Media Operations
Performs the following tasks:
• Move tape—Select a Source and Element Type (where you want to
move a tape from)andaDestination and Element Type (where you
want to move a tape to).
Element types consist of a tape drive, load port (I/O), or slot location.
Numbers ca n be entered from the keypad. The up/d own arrows
cycle you through full (source) or empty (destination) locations.
After choosing a source and destination, select Move.
Run Admin Tests
Performs the f
ollowing tests:
• Screen
•AlignScreen
—Touch and release the screen near the rectangle
in the center
. As you approach the rectangle at some point, it
changes col
or. The color change takes place when the border
of the rectangle is touched. This is where the touch pad and
visual scr
een should be aligned. Use the Up/Down/Left/Right
buttons to
align the screen.
There is no visual effect when using the adjustment buttons.
Usethetouchscreenagaintomakesurethattheadjustmentis
how you want it. Select the Save tab to make the adjustments
permanent.
• Colors—Displays the range of colors available to the OC P.
• Pixel—Tests for bad screen pixels. Select the Test button to turn
all pixels black. Touch the screen to turn all pixels white. T ouch
the screen again to end the test.
• Version—Displays the version of the OCP firmware.
• Backlight Off—When pressed, turns the OCP backlight off.
• Inventory Library—Per forms an inventory of all the tape cartridges
in a li
brary. Unlabeled tapes are shown as FULL if the library has
been
configured to detect unlabeled tapes.
• Run D
emo—Per forms tape swaps between slots and load por ts. Set
the n
umber of loops to be performed (must be at least one). When
the
demo completes, the tape cartridges are back in their original
configuration.
• RunSelfTest—Initializesthemechanicsandperformsteststomake
sure the library is functioning correctly. Tests include verifying the
st
atus of all components; tape exchanges between storage slots,
l
oad port slots, and tape drives; and corner-to-corner slot exchanges.
When the self test completes, the tape cartridges are back in their
original locations.
• Slot test—P erforms a r epeated move of a tape from one slot to
another. Select the source slot, the destin ation slot, and the loop
count, and then select Start Test.
• Drive Load/Unload Test—Moves media into and out of each tape
drive for a specified number of loops.
• ForceRewindUnloadTest—Clearsthepreventmediaremovalbit
for a tape drive and unloads the tape cartridge to its original slot
or to the first empty slot. Interrupts the tape drive operation that is
currently running, if any. Use the Up and Down arrows to select the
tapedrivethatyouwanttoforcerewindunload.
• Recalibrate library—Recalibrates all the targets in the library.
Support screen
The Support screen provides a ccess to screens showing HP support information, service tasks, contact
information, and allows you to display the library time.
54
Using the library