HP StorageWorks Enterprise Modular Library E-Series user guide (AH876-96001, October 2007)

Table 5 Status sc reen functions
Function Description
Identity Screen
Contains basic configuration information. The library name and IP
address is obta
ined from Command View TL. Other information comes
from the robot
firmware.
The number of in
terface controllers and tape drives installed in the
library are li
sted,aswellasthetotalnumberofavailablestorageslots.
For example, load port slots configured as storage slots are counted in
the total of a
vailable slots, while load ports used to m ove tape cartridges
in and out of the library are not counted in the total.
This screen also shows the library model, library serial number, and
library firmware version.
Health Summary
Displays a status icon and health information for the library, robot,
power supplies, load ports, tape drives, interface controllers, and
Interface Manager card.
Component Status
Identifies the status of th e overall library and individual components:
• Library and Robotics—Displays library and robotics characteristics,
and tape drive odometer. The odometer counts the number of loads
for each tape drive. The load count is reset when a tape drive is
replaced.
• Individual Drive Status—Displays detailed tape drive information for
each tape drive on individual screens. Select the Pa ge Up and Page
Down tabs to move between available tape drives.
• All Drive Summary—Displays an overall status of all installed tape
drives and whether they contain tape cartridges.
• Interface Controller Status—Displays the status for individual interface
controllers, showing the number of host ports, device ports, a nd
firmware revision.
• Interface Manager Status—Displays health a nd configuration
characteristics of the Interface Manager card.
Event Log Type Selection
Allows you to filter informational, warning, and critical events. The
five m
ostrecenteventsofanycategoryaredisplayedwiththeoldest
displayed firstandthemostrecentdisplayedlast. Filteringeventsdoes
not
remove them from the log.
View Library Inventory
Identifies the status of each tape drive and slot location.
Configuration screen
The Configuration screen provides administrator access to screens that allow you to change the library
configuration or adjust the contrast of the OCP screen.
50
Using the library