HP StorageWorks Enterprise Modular Library E-Series Interface Manager card CompactFlash replacement instructions (AD560-96042, August 2008)

Identify the Interface Manager card
10539
The Interface Manager card is located in the bottom slot of the base
module card cage.
Label and un
plug the cables
11800a
Label the cables or write a note that shows the locations of all the cables
plugged into the Interface Manager card to make it easier to reconnect
them later. Unplug all cables from the I nterface Manager card.
Remove th
eInterfaceManagercard
10541a
Use a #1 P
hillips screwdriver to loosen the captive screws in the black
ejecto
r handles at the ends of the Interface Manager card. Push the
ejecto
r handles to the outside, then pull on them to remove the card.
CAUTION:
Be aware that the metal tabs on the gasket on the filler panel can
be caught and bent by the pins on the Interface Manager card.
If bent, these tabs can cause a short circuit. Avoid removing or
installing the Interface M anager card at an angle and watch that
the metal tabs on the gasket do not get caught or bent.
Remove the original CompactFlash card
10032a
Grasp the edge
s of the CompactFlash card and slide it out of the flash
memory slot. If needed, push a pen into the corner notches of the
CompactFlash slot to unseat it.
Insert the new CompactFlash card
10033a
With the connector going in first, align the sides of the CompactFlash
card with the slot on the Interface Manager card. Gently slide the
CompactFlash card into the slot until it is securely seated. If the
CompactFlash card does not slide in easily, it is upside down.
Reinstall the Interface Manager card
10542a
Align the Interface Manager c ard with the guides in the base module
card cage and slide the Interface Manager card into the library. Push
theejectionhandlestotheinsidetofullyseatthecard. Tightenthe
captive screws.
Page 2