HP StorageWorks EML E-Series Ultrium 1840 tape drive moduleupgrade or replacement service guide (AH682-96001, October 2007)

4.7 Connect the E
thernet cable
11559
1
2
1) Connect on
e end of the Ethernet cable included with the tape drive
to the MGMT p
ort on the tape drive. 2) Connect the other end of the
Ethernet ca
ble to the internal network switch installed in the library. Do
not connect
the MGMT port or internal network switch to the public
or site LAN
.
4.8 Configure the library and SAN
Insert new LTO4 media if desired.
Reset the library settings
Reset the library to the factory defaults so the library will discover the
new components and forget the o ld components.
Configure the components
Use Command View TL or the Interface Manager CLI to enter the host
mapping, access control, and FC speed settings for all components.
See the HP StorageWorks Interface Manager and Command View TL
User’s Guide for detailed instructions.
Configure the SAN switch
Rezone the SAN, if n ecessary, to account for the new hardware and
paths.
Reboot the SAN FC switch if necessary .
4.9 Verify connectivity
11558
26
Verify that t
he Fibre Channel port A LED on the new tape drive is green
when connect
ed to a sw itch and linked.
4.10 Close the doors
10545
Close the back doors of the library.
4.11 Upgrade the drive firmware
Ensure that the tape drive has the latest firmware for correct operation.
If necessary, upgrade the drive firmware using the Command View
TL firmware upgrade wizard or the Interface Manager’s Command
Line Interface. See the HP StorageWorks Interface Ma nager and
Command View TL User’s Guide for detailed procedures on upgrading
drive firmware.
NOTE:
A new drive will not be recognized by the library until after a
reboot.
Page 5