HP StorageWorks EML E-Series Ultrium 1840 Tape Drive Module upgrade or replacement (AH682-96003, July 2008)

3. Remove the old ta
pe drive.
a. Identif y the tap
e drive to be replaced. The fault LED might
be lit.
11547
b. Disconnect the Fibre Channel (FC) cab le from the drive to be
replaced by pressing down on the cable connector tab and
pulling t
he connector away from the drive.
11548
c. Unplug the Ethernet cable from the MGMT port.
d. If necessary, use a screwdriver to loosen the captive screw at
the right side of the drive module. G rasp the drive and pull it
from the drive bay.
11549
4. Install the new tape drive.
a. Remove the end cap from the port A FC conn ector on the new
tape drive.
11551
b. Insertthenewdrivemoduleintothevacantdrivebayand
tighten the captive screw to secure the drive to the chassis.
5. Connect the FC cable.
CAUTION:
To avoid damaging FC cables, do not pinch or bend the cables
sharper than a 5 cm (2 inch) diameter.
a. Reconnect the end of the FC cable that you disconnected from
theoldtapedrivetotheportAFCconnectoronthenewdrive.
The FC cable clicks into place.
11552
b. Verify that the oth er end of the FC cable is connected to its
corresponding port on the SAN.
Page 10