HP StorageWorks EML E-Series Tape Library Internal Network Kit Installation and Replacement Instructions (AJ001-96002, May 2010)

14 Connect the switch to the Interface
Manager card
Connect an Ethernet cable from port 24 on the switch to any TO
CONTROLLER/DEVICE PORTS on the Interface Manager card (bottom
card in the card cage in the base module).
15 Install the cable clamps and route the
cables
Attach the cable clamps to the right rear rack at the positions 37T, 26T,
and 15T. Use these cable clamps to route the tape drive Ethernet cables.
16 Plug the power cable from the switch
into the power strip
17 Verify that the power and link LEDs
on the switch are solid green
18 Close the back doors of the rack
HP web sites
For additional information, see the following HP web sites:
• http://www.hp.com
• http://www.hp.com/go/storage
• http://www.hp.com/service_locator
• http://www.hp.com/support/manuals
Page 4