HP StorageWorks EML E-Series Tape Library Internal Network Kit Installation and Replacement Instructions (AJ001-96002, May 2010)

3 Unplug the switch from the power strip
4 Label the cables plugged into the
switch
Label the cables or write a note that shows the locations of all the cables
plugged into the switch to make it easier to reconnect them later.
5 Unplug all cables from the switch
6 Remove the switch from the rack
Remove the screws that attach the switch to the cabinet with a #2 Phillips
screwdriver and remove the switch from the rack.
7 Unplug the power cable from the back
of the switch
8 Remove the brackets from the switch
Use a #2 Phillips screwdriver.
Page 2