HP StorageWorks EML E-Series Tape Library Internal Network Kit Installation and Replacement Instructions (AJ001-96001, September 2007)

14 Connect the switch to the Interface
Manager card
Connect an Ethernet cable from port 24 on the switch to any TO FIBRE
CHANNEL PORT on the Interface Manager card (bottom card in the
card cage in the base module).
11651
15 Install the cable clamps a nd route
the cables
11670
26
Attach the cable clamps to the right rear rack at the positions 37T, 26T,
and 15T. Use these cable clamps to route the tape drive Ethernet cables.
16 Plug the power cord from the switch
into the power strip
11583
17 Verify that the power and link LEDs
on the switch are solid green
11584
18 Close the back doors of the rack
10545
HP web sites
For additional information, see the following HP web sites:
•h
ttp://www.hp.com
•http://www.hp.com/go/storage
•http://www.hp.com/service_locator
•http://www.hp.com/support/manuals
Page 4