HP StorageWorks e2400-FC 4G Interface Controller User and Service Guide (December 2005)

e2400-FC 4G Fibre Channel Interface Controller User Guide 19
A Regulatory compliance notices
This section contains regulatory notices for the HP StorageWorks e2400-FC 4G interface
controller.
When the e2400-FC 4G controller is properly installed in an HP StorageWorks EML or ESL series
tape library, continued compliance has been demonstrated to the following regulatory
requirements as a class A device.
This product contains laser components. See Class 1 laser statement in Laser compliance.
Battery statement
WARNING! This product contains one lithium battery. The battery is yellow and can be removed.
It has the words "lithium battery" visible on the top.
Lithium may be considered a hazardous material. Dispose of these batteries in accordance with
local, state, and federal laws. In addition:
• Do not attempt to recharge the battery if removed from the board.
• Do not expose the batteries to water or to temperatures higher than 60C (140F).
• Do not disassemble, crush, puncture, short external contacts, or dispose of in fire or water.
• Do not short external contacts or dispose of in fire or water.
• Replace batteries only with the designated HP spares.
Batteries, battery packs, and accumulators should not be disposed of together with general
household waste. To forward them to recycling or proper disposal, please use the public collection
system or return them to HP, an authorized HP Partner, or their agents.
For more information about battery replacement or proper disposal, contact an authorized reseller
or an authorized service provider.
Federal Communications Commission notice
Part 15 of the Federal Communications Commission (FCC) Rules and Regulations has established
Radio Frequency (RF) emission limits to provide an interference-free radio frequency spectrum.
Many electronic devices, including computers, generate RF energy incidental to their intended
function and are, therefore, covered by these rules. These rules place computers and related
peripheral devices into two classes, A and B, depending upon their intended installation. Class A
devices are those that may reasonably be expected to be installed in a business or commercial
environment. Class B devices are those that may reasonably be expected to be installed in a
residential environment (i.e., personal computers). The FCC requires devices in both classes to bear
a label indicating the interference potential of the device as well as additional operating
instructions for the user.