HP EliteBook Revolve 810 G2 Maintenance and Service Guide

Display assembly
Description Spare part number
Display Hinge up 11.6 HD AG UWVA 753720-001
Before removing the display assembly, follow these steps:
1. Turn off the computer. If you are unsure whether the computer is off or in Hibernation, turn the
computer on, and then shut it down through the operating system.
2. Disconnect the power from the computer by unplugging the power cord from the computer.
3. Disconnect all external devices from the computer.
4. Remove the battery (see
Battery on page 28), and then remove the following components:
a. Service door (see
Service door on page 30)
b. WWAN module (see
WWAN module on page 32)
c. WLAN module (see
WLAN module on page 34)
d. Solid-state drive (see
Solid-state drive on page 35)
e. Keyboard (see
Keyboard on page 41)
f. Top cover (see
Top cover on page 45)
g. Fan/heat sink assembly (see
Fan/heat sink assembly on page 53)
h. System board (see
System board on page 55)
i. Hinge cover and hinge cap (see
Hinge cover on page 58)
Remove the display assembly:
1. Remove the two Phillips M2.0×5.0 screws (1) that secure the display assembly to the top cover.
60 Chapter 6 Removal and replacement procedures for Authorized Service Provider parts