FW 07.00.00/HAFM SW 08.06.00 McDATA E/OS SNMP Support Manual (620-000131-620, April 2005)

B
B-34
E/OS SNMP Support Manual
FC Management MIB
NOTE: Each implementation may chose not to allow any or all of these
values on a SET. On a read, if you do not support write, then return invalid.
Otherwise return the last control operation attempted.
Sequence ::= { connUnitPortEntry 16 }
connUnitPortName
Syntax DisplayString
Access read-write
Status mandatory
Description A user-defined name for this port. This means that up to
DisplayString characters may be supported. If less than, then the
name will be truncated in the connunit.
offlineConnUnitPort: If the addressed connUnit allows this
operation to be performed to this port,
the addressed port performs a
vendor-specific 'offline' operation.
Examples of these operations are
disabling a port's transceiver, the Link
Failure protocol, request
(NON-PARTICIPATING) command to
the Loop Port state machine, or removal
of the port from an arbitrated loop by a
hub.
onlineConnUnitPort: If the addressed connUnit allows this
operation to be performed to this port,
the addressed port performs a
vendor-specific 'online' operation.
Examples of these operations are
enabling a port's transceiver, the Link
Failure protocol, request
(PARTICIPATING) command to the
Loop Port state machine, or addition of
the port from an arbitrated loop by a
hub.
resetConnUnitPortCounters: If the addressed connUnit allows this
operation to be performed to this port,
the addressed port statistics table
counters will be set to zero.