FW 07.00.00/HAFM SW 08.06.00 McDATA E/OS SNMP Support Manual (620-000131-620, April 2005)

B
Port Table
B-33
FC Management MIB
Description This object is used to control the addressed connUnit's port. Valid
commands are:
resetConnUnitPort: If the addressed connUnit allows this
operation to be performed to this port,
the addressed port performs a
vendor-specific 'reset' operation.
Examples of these operations are: the
Link Reset protocol, the Loop
Initialization protocol, or a
resynchronization occurring between
the transceiver in the addressed port to
the transceiver that the port is
connected to.
bypassConnUnitPort: If the addressed connUnit allows this
operation to be performed to this port,
the addressed port performs a
vendor-specific 'bypass' operation.
Examples of these operations are
transitioning from online to offline, a
request (NON-PARTICIPATING)
command to the Loop Port state
machine, or removal of the port from an
arbitrated loop by a hub.
unbypassConnUnitPort: If the addressed connUnit allows this
operation to be performed to this port,
the addressed port performs a
vendor-specific 'unbypass' operation.
Examples of these operations are the
Link Failure protocol, a
request(PARTICIPATING) command to
the Loop Port state machine, or addition
of the port to an arbitrated loop by a
hub.