FW 05.01.00 and SW 07.01.00 HP StorageWorks CLI Reference Guide for Directors and Edge Switches (AA-RQ7AD-TE, June 2003)

config.port.type
59CLI Reference Guide for Directors and Edge Switches
Syntax
type portNumber portType
Purpose
This command sets the allowed type for a port.
Description
A port can be configured as an F_Port, an E_Port, or a G_Port. On an Edge Switch
2/24, a port can also be an Fx_Port or Gx_Port. The port configurations function
as follows:
F_Port—cannot be used as an interswitch link, but may attach to a device with
an N_Port.
E_Port—only other switch may attach to this type of port.
G_Port—either a device or another switch may attach to this type of port.
Fx_Port — allows Arbitrated Loop operation in addition to the functionality
of an F_Port. (Edge Switch 2/24 only.)
Gx_Port—allows Arbitrated Loop operation in addition to the functionality of
an F_Port or an E_Port. (Edge Switch 2/24 only.)
Parameters
This command has two required parameters:
config.port.type
portNumber Specifies the port number. Valid values are:
0–15 for the Edge Switch 2/16
0-23 for the Edge Switch 2/24
0–31 for the Edge Switch 2/32
0–63 for the Director 2/64
0-127 and 132-143 for the Director 2/140