FW 05.01.00 and SW 07.01.00 HP StorageWorks CLI Reference Guide for Directors and Edge Switches (AA-RQ7AD-TE, June 2003)

Error Messages
239CLI Reference Guide for Directors and Edge Switches
Error 230: Invalid WWN The WWN parameter
does not contain a valid
value.
For the appropriate
parameters, see the
section of the manual that
corresponds to the
attempted command.
Parameters must be typed
exactly to specification to
be recognized correctly
by the CLI.
Error 231: Invalid Port
Number
The value specified for the
portNumber parameter is
invalid.
Refer to Chapter 2 for
information about the
commands with the
portNumber parameter.
Specify a valid port
number value, and
resubmit the command.
Error 232: Invalid Domain
ID
The value specified for the
domainId parameter is
invalid. For example, the
domainId parameter of
the
config.switch.pref
DomainId command
requires an integer in the
range 1–31.
Refer to Chapter 2 for
information about the
commands with the
domainId parameter.
Specify a valid domain ID
value, and resubmit the
command.
Error 233: Invalid
Member
The value specified for the
zoneName parameter
(the name of the zone
member) is invalid.
Refer to Chapter 2 for
information about the
commands with the
zoneName parameter.
Specify a valid name for
the zone member, and
resubmit the command.
Table 5: CLI Error Messages (Continued)
Message Description Action