FW 05.01.00 and SW 07.01.00 HP StorageWorks CLI Reference Guide for Directors and Edge Switches (AA-RQ7AD-TE, June 2003)

Error Messages
236 CLI Reference Guide for Directors and Edge Switches
Error 212: Duplicate Zone
Member
The entered command
tried to add a member
that already exists in the
zone.
No action required
Error 213: Number of
Zones Is Zero
The
config.zoning.activateZon
eSet command tried to
activate a zone set
contained in the work
area to the fabric;
however, the zone set is
empty.
A zone set must have at
least one zone to be a
valid zone set. Add at
least one zone to the zone
set, and then reenter the
config.zoning.activateZon
eSet command to activate
the zone set in the work
area to the fabric.
Error 214: A Zone
Contains Zero Members
The
config.zoning.activateZon
eSet command tried to
activate the zone set
contained in the work
area to the fabric;
however, the zone set
contains at least one zone
that is empty.
Each zone in the zone set
must contain at least one
zone member. Add zone
members so that each
zone has at least one
zone member; then
reenter the
config.zoning.activateZon
eSet command to activate
the zone set in the work
area to the fabric.
Error 215: Zone Set Size
Exceeded
The size of the local
work-area zone set has
outgrown the size
supported by the CLI.
Reduce the size of the
zone set to meet CLI
requirements by doing
one or more of the
following:
■ reduce the number of
zones in the zone set
■ reduce the number of
members in a zone
■ reduce the length of
zone names
Table 5: CLI Error Messages (Continued)
Message Description Action