FW 05.01.00 and SW 07.01.00 HP StorageWorks CLI Reference Guide for Directors and Edge Switches (AA-RQ7AD-TE, June 2003)

Error Messages
231CLI Reference Guide for Directors and Edge Switches
Error 135: Invalid
Number of Fabric
Membership List Entries
The number of fabric
members submitted
exceeds the maximum
allowable entries of 31.
The number of entries in
the Fabric Membership
List is limited to the total
number of domain IDs
available to the fabric.
Make sure that the list
(including the managed
switch) contains no more
than 31 entries.
Error 136: Invalid
Number of Switch
Membership List Entries
The number of switch
members submitted
exceeds the maximum
allowable entries of 256.
The number of entries in
the Switch Membership
List is limited to 256.
Make sure that the list
(including the managed
switch) contains no more
than 256 entries.
Error 137: Invalid Fabric
Binding State
The fabric binding state
submitted is not
recognized by the CLI.
The fabric binding state
must be set either to
inactive or restrict. For
more information, see
config.security.fabricBindi
ng Commands on
page 61.
Error 138: Invalid Switch
Binding State
The switch binding state
submitted is not
recognized by the CLI.
The switch binding state
must be set to one of the
following: disable,
erestrict,
frestrict, or
allrestrict. For more
information, see
config.security.switchBindi
ng Commands on
page 78.
Error 139: Insistent
Domain ID's Must Be
Enabled When Fabric
Binding Active
The user attempted to
disable insistent domain
IDs while fabric binding
was active.
Insistent domain IDs must
remain enabled while
fabric binding is active. If
fabric binding is set to
inactive, the insistent
domain ID state may be
changed. It should be
noted, however, that this
can be disruptive to the
fabric.
Table 5: CLI Error Messages (Continued)
Message Description Action