FW 05.01.00 and SW 07.01.00 HP StorageWorks CLI Reference Guide for Directors and Edge Switches (AA-RQ7AD-TE, June 2003)

config.system.show
115CLI Reference Guide for Directors and Edge Switches
config.zoning Commands
The config.zoning commands function in a different way from the other CLI
commands, which are single action commands that take effect immediately. A
zoning configuration is typically too complicated to be described by a single
command, so the first zoning command entered invokes a work-area editor. The
commands take effect on a temporary copy of a zone set in the work area until the
temporary copy in the work area is activated to the fabric — or is discarded.
Because not all the verification of the zone set can occur on the temporary copy in
the work area, it is possible, however unlikely, that the copy of the zone set
encounters no errors until the zone set is activated to the fabric.
Note: Port numbers cannot be used for zone members if the interoperability mode for
the switch or director is set to Open Fabric 1.0 mode. In this case, you must use node
WWNs as zone members.
The config.zoning commands include the following:
■ config.zoning.setDefZoneState
■ config.zoning.activateZoneSet
■ config.zoning.deactivateZoneSet
■ config.zoning.replaceZoneSet
■ config.zoning.clearZoneSet
■ config.zoning.addZone
■ config.zoning.deleteZone
■ config.zoning.renameZoneSet
■ config.zoning.addWwnMem
■ config.zoning.addPortMem
■ config.zoning.clearZone
■ config.zoning.deleteWwnMem
■ config.zoning.deletePortMem
■ config.zoning.renameZone
■ config.zoning.showPending
■ config.zoning.showActive