HP StorageWorks Clustered Gateway (server/software bundle) 3.6.1 Windows Storage Server Edition upgrade guide (AG515-96012, September 2008)

Chapter 2: Upgrade procedure 12
Post-Upgrade Procedures
If HP Command View EVA v5.x is Present
1. Rename file 'SSSU.exe' present in folder C:\Program Files\Hewlett
Packard\Sanworks\Element Manager for Storageworks HSV\Bridge to
SSSU_x64_8.exe. (This file is SSSU version 8 and can be used when
environment is migrated to HP Command View EVA v8 in the future.)
2. Restore the file sssu.exe that you had backed up as part of 'Pre-upgrade
procedures' to this location.
If HP Command View EVA v6.x is Present
After all the nodes in the cluster have been upgraded to CGW 3.6.1
complete the following steps:
1. Rename file 'SSSU.exe' present in folder C:\Program Files\Hewlett
Packard\Sanworks\Element Manager for Storageworks HSV\Bridge to
SSSU_x64_8.exe. (This file is SSSU version 8 and can be used when
environment is migrated to HP Command View EVA v8 in the future.)
2. Rename the file 'SSSU6.exe' in folder C:\Program Files\Hewlett
Packard\Sanworks\Element Manager for Storageworks HSV\Bridge to
'SSSU.exe'.
3. Re-configure the snapshot configuration on one node in the cluster:
a. On the Management Console, go to Tools > Configuration Utility.
Click the Cluster-wide Configuration tab in the Configure Cluster
window, and stop service on this node.
b. Click the Storage Settings tab. Under Snapshot Configuration,
click the existing entry and then click Remove.
c. Click Add, and enter the IP address, username and password of
the HP Command View v6 manager.
d. Click the Test configuration tab, and if the configuration is
successful, click Apply.
e. Go to the Cluster-wide Configuration tab, and export the
configuration to the other nodes in the cluster.