HP StorageWorks Clustered Gateway (server/software bundle) 3.6.0 Windows Storage Server Edition Upgrade Guide (5697-7456, April 2008)

Chapter 2: Upgrade procedure 10
7. Click the Import tab, and enter IP address/host name of a node
already upgraded to 3.6.0. This will import configuration settings
from that node.
8. Go to the Cluster-Wide configuration tab. Select the current node and
click StartService. This will start HPCFS 3.6.0 service on that node.
NOTE: The drive letter assignment may have changed in the node that
was upgraded to 3.6.0. To restore the original drive letter
assignment to all the filesystems and dynamic volumes, run the
command 'dledit -p' from path 'C:\Program Files\Hewlett-
Packard\HP Clustered File System\bin'.
Post-Upgrade Procedures
If HP Command View EVA v5.x is Present
1. Rename file 'SSSU.exe' present in folder C:\Program Files\Hewlett
Packard\Sanworks\Element Manager for Storageworks HSV\Bridge to
SSSU_x64_6.exe. (This file is SSSU version 6 and can be used when
environment is migrated to HP Command View EVA v6 in the future.)
2. Restore the file sssu.exe that you had backed up as part of 'Pre-upgrade
procedures' to this location.
If HP Command View EVA v6.x is Present
After all the nodes in the cluster have been upgraded to CGW 3.6.0
complete the following steps:
NOTE: No change is required for the SSSU.exe executable.
1. Re-configure the snapshot configuration on one node in the cluster:
a. On the Management Console, go to Tools > Configuration Utility.
Click the Cluster-wide Configuration tab in the Configure Cluster
window, and stop service on this node.
b. Click the Storage Settings tab. Under Snapshot Configuration,
click the existing entry and then click Remove.