HP StorageWorks Clustered File System 3.6.1 Windows Storage Server Edition event notification guide (AG515 - 96011, August 2008)

Chapter 3: Event Messages 34
13929 Membership Partition <partition> does not belong to this cluster; cannot use.
Action. Determine whether the specified membership partition belongs to
this cluster. Use the Storage Settings tab on the Configure Cluster window
or the mpdump command to see the membership partitions configured for
the cluster. If the partition does belong to the cluster, first verify that no
other cluster is using it. Then stop HP Clustered File System on all nodes
and run the command mprepair --sync-clusterids. See the HP StorageWorks
Clustered File System Administration Guide for more information about this
command.
13930 Cluster now owns Membership Partition <partition>; problem resolved.
Action. None. Alert 13929 is resolved.
13933 FenceAgent <IP_address>: no response to queries from <server>.
Fabric fencing is configured and a node has lost network access or the
FibreChannel switch is unresponsive.
Action. Possible causes of the error are:
• The server has experienced a total loss of network access to the
FibreChannel switch(es).
• A FibreChannel switch has become unresponsive to snmp requests.
• The dependent r/w community string has been changed or deleted.
For the Cisco MDS FibreChannel switch with firmware version 2.1 or later,
the default VSAN (VSAN 1) is likely disabled, which causes
fcFeFabricName (FA-MIB defined) to be unassigned (all zeros). Currently
HP Clustered File System uses the OID assignment for fcFeFabricName to
probe connected FC switches and will return the above error messages if it is
unable to determine a value for fcFeFabricName. The messages can be
quiesced by enabling the default VSAN (VSAN 1).
The following utility specifies whether a server can communicate with the
FibreChannel switch. The command displays the name service entries of the
WWPN and the Fabric IDs of the switch. It may take approximately five or
six seconds for the output to be displayed.
PSANinfo -c <snmp community string> <IP address of FC
switch>
13934 FenceAgent <IP_address>: no response to queries from <server> resolved.
Action. None. Alert 13933 is resolved.
ID Message and Corrective Action