HP StorageWorks Clustered File System 3.6.1 for Windows installation guide (AP809-96008, October 2009)

Chapter3:InstallHPStorageWorksClusteredFileSystem 16
#(This parameter should not be set except in very specific cases!)
#
#allow_any_disk 0
Onthelastline,removethe#signprecedingallow_any_diskand
changethevalueto1:
allow_any_disk 1
Tosetno_permanent_mountpoints,locatetheselinesinthescl.conf
file:
# no_permanent_mountpoints
#(This parameter is only for Windows; it has no affect on Linux)
#Indicates whether scl utilities will create 'permanent' mountpoints
#for all imported device partitions. (They are permanent in that
#they will persist until the disk is deported).
#
#Note that on W2K3 Enterprise, by default, devices cannot be
#accessed without either a driveletter assignment or a mountpoint
#assignment. Hence turning on 'no_permanent_mountpoints' may prevent
#MatrixServer from operating properly.
#
#Set to 1 to disable creation of permanent mountpoints.
#(default behavior is that scl will create permanent mountpoints
#for all imported devices.)
#
#no_permanent_mountpoints 0
Onthelastline,removethe#signpreceding
no_permanent_mountpointsandchangethevalueto1:
no_permanent_mountpoints 1
10. Configure FC Switches
NOTE: ForallFCswitches,itisbestpracticetoplaceeachHBAportand
itsstorageportsinaseparatezone.NootherinitiatorHBAport
shouldbepresentinthiszone.
Whencertainproblemsoccuronaserver(forexample,hardware
problemsorthelossofclusternetworkcommunications),and
theserver