HP StorageWorks Clustered File System 3.6.1 for Windows installation guide (AP809-96008, October 2009)

Chapter3:InstallHPStorageWorksClusteredFileSystem 15
software.ForinformationaboutHP’sMPIOsoftwareforHParrays,check
thefollowinglink:
http://h18006.www1.hp.com/products/sanworks/softwaredrivers/
multipathoptions/windows.html.
9. Set Parameters for MPIO Software
DifferentMPIOsoftwaresolutionsmayrequirespecificconfiguration
steps.ThissectiondocumentsknownsetupforHP’sMPIOsoftwarein
orderforittoworkwithHPClusteredFileSystem.
HP MPIO DSM
Noadditionalsetupisrequiredafterthissoftwarehasbeeninstalled.
NotethattherearedifferentMPIODSMpackagesfordifferentHP
arrays.
AlsonotethattherearecompatibilityrestrictionsonwhichMPIODSM
packagescanco‐existonthesamesystem.Thelatestinformationcanbe
foundat:
http://h18006.www1.hp.com/products/sanworks/softwaredrivers/
multipathoptions/windows.html.
HP SecurePath
TheHPSecurePathproductisnotincludedaspartofHPClusteredFile
System.HPrecommendstheuseofthenewerMPIODSMsoftware.
However,SecurePathsoftwareisknowntoworkandissupported.
TheHPClusteredFileSystemallow_any_diskand
no_permanent_mountpointsparametersmustbesetmanuallyon
eachserver.These
parametersarelocatedinthescl.conffile,whichby
defaultislocatedatC:\ProgramFiles\Hewlett‐Packard\HPClustered
FileSystem\conf\scl.conf.
Tosettheallow_any_diskparameter,locatetheselinesinthescl.conf
file:
# allow_any_disk
#Perform no checking to ensure that paths to disks go through
#the managed SAN. Set to 1 to enable, 0 to disable.
#(default behavior is "disabled").
#