HP StorageWorks Clustered File System 3.6.0 Windows Storage Server Edition Setup Guide (403102-005, January 2008)

Chapter 3: Setting Up HP StorageWorks Clustered File System 36
All of the available partitions on that disk or LUN then appear in the
bottom of the window. Select one of these partitions and click Add.
(The minimum size for a membership partition is 1 GB.) Repeat this
procedure to select two more membership partitions. We recommend
that the partitions be on different disks.
When selecting partitions for use as membership partitions, be sure
that they do not contain any needed data. When the membership
partitions are created, any existing data will be erased.
2. Snapshot configuration. HP Clustered File System supports
hardware array-based snapshots. If you want to use this capability,
you will need to configure the snapshot method.
NOTE: Array-based hardware snapshots are supported on Hewlett-
Packard StorageWorks Enterprise Virtual Array (EVA) storage
arrays. The appropriate HP software must be installed as
described under step “15. Install Hardware Snapshot Software
(Optional)” on page 22.
To configure the snapshot method, click Add, select the appropriate
method, and then supply any requested configuration information.
HP-EVA storage array. You will be asked for the hostname and
authentication information for the management appliance.