HP StorageWorks Clustered File System 3.6.0 Windows Storage Server Edition Installation Guide (418975-003, January 2008)

Chapter 3: Install HP StorageWorks Clustered File System 40
All of the available partitions on that disk or LUN then appear in the
bottom of the window. Select one of these partitions and click Add.
(The minimum size for a membership partition is 1 GB.) Repeat this
procedure to select two more membership partitions. We recommend
that the partitions be on different disks.
When selecting partitions for use as membership partitions, be sure
that they do not contain any needed data. When the membership
partitions are created, any existing data will be erased.
2. Snapshot configuration. HP Clustered File System supports
hardware array-based snapshots. If you want to use this capability,
you will need to configure the snapshot method.
NOTE: Array-based hardware snapshots are supported on Engenio
storage arrays and Hewlett-Packard StorageWorks Enterprise
Virtual Array (EVA) storage arrays. The appropriate Engenio
or HP software must be installed as described under step “15.
Install Hardware Snapshot Software (Optional)” on page 26.
To configure the snapshot method, click Add, select the appropriate
method, and then supply any requested configuration information.
HP-EVA storage array. You will be asked for the hostname and
authentication information for the management appliance.