HP StorageWorks Clustered File System 3.2.1 Windows Storage Server Edition Setup Guide (February 2006)

Chapter 3: Setting Up HP StorageWorks Clustered File System 16
allow_any_disk 1
To set no_permanent_mountpoints, locate these lines in the scl.conf
file:
# no_permanent_mountpoints
#(This parameter is only for Windows; it has no affect on Linux)
#Indicates whether scl utilities will create 'permanent' mountpoints
#for all imported device partitions. (They are permanent in that
#they will persist until the disk is deported).
#
#Note that on W2K3 Enterprise, by default, devices cannot be
#accessed without either a driveletter assignment or a mountpoint
#assignment. Hence turning on 'no_permanent_mountpoints' may prevent
#MatrixServer from operating properly.
#
#Set to 1 to disable creation of permanent mountpoints.
#(default behavior is that scl will create permanent mountpoints
#for all imported devices.)
#
#no_permanent_mountpoints 0
On the last line, remove the # sign preceding
no_permanent_mountpoints and change the value to 1:
no_permanent_mountpoints 1
11. Configure the Cluster
Provide the following information:
• The IP address or hostname of each server that will be in the cluster.
• The location of your HP Clustered File System license file.
• A secret network key that provides security for network
communications among the cluster servers.
• An administrative password for configuring the cluster.
• The fencing method that you want to use (either FibreChannel
switch-based fencing or Web Management-based fencing via server
reset/shutdown).