HP StorageWorks Clustered File System 3.1.1p1 Linux Edition Upgrade Guide (February 2006)

Chapter 3: Rolling Upgrade Procedure 9
Run this command on the server:
# rpm -e pmxs
The following message then appears:
Stopping HP StorageWorks Clustered File System
This server needs to be rebooted before the product removal
can proceed.
/etc/init.d/pmxs has been moved to /etc/init.d/Pmxs to avoid
HP StorageWorks Clustered File System from starting automatically
on boot.
error: %preun(pmxs-<ver>-release) scriptlet failed, exit status 1
Reboot the server and run the rpm -e command again. HP Clustered
File System will now be uninstalled.
NOTE: When the uninstall is complete, you will see a message listing
files and directories that could not be removed. Do not
manually remove any of these files.
9. Uninstall the Management Console:
# rpm -e mxconsole
10. Install the HP Clustered File System 3.1.1p1 Support RPM and rebuild
the kernel as described in Appendix A (SLES 9).
11. Install HP Clustered File System 3.1.1p1 from the HP Clustered File
System product CD or the location where you have downloaded the
software.
# rpm -i pmxs-3.1.1p1-<xxxx>.x86_64.rpm
12. Install the Management Console:
# rpm -i mxconsole-3.1.1p1-<xxxx>.x86_64.rpm
13. Install the CFS-Linux support RPM from the CFS-Linux product CD
or the location where you have downloaded the software.
# rpm -i mxfs-support-3.1.1p1-<xxxx>.x86_64.rpm
Then install CFS-Linux 3.1.1p1 from the product CD or the location
where you have downloaded the software.
# rpm -i mxfs-3.1.1p1-<xxxx>.x86_64.rpm