HP StorageWorks Clustered File System 3.1.1 for Linux Installation Guide (May 2006)

Appendix B: Configure the Cluster from the Command Line 68
Add the Remaining Servers to the Cluster
To add another server to the cluster, select Cluster > Server > New and
enter the name or IP address of the server on the New Server window.
Repeat this procedure to add the remaining servers to the cluster. The
Management Console will show that the servers are down because
Clustered File System is not yet running on them.
Start Clustered File System on the Remaining
Servers
Run the following script on each server that you added to the cluster.
# /etc/init.d/pmxs start
NOTE:
When Clustered File System is started on a new server,
ClusterPulse updates the SAN information on that server. During
the update, the Management Console may be unable to report
SAN information. You can ignore this; the cluster is operating
correctly and the SAN information will reappear within a few
seconds.
The installation is now complete. See the HP Clustered File System
Administration Guide for information about configuring the cluster.