HP StorageWorks Clustered File System 3.1.1 for Linux Installation Guide (May 2006)

Appendix B: Configure the Cluster from the Command Line 58
Configure FibreChannel Switches
On the SAN Configuration window, specify the hostnames or IP
addresses of the FC switches that are directly connected to the nodes in
the cluster. (If you are using Web Management-Based Fencing, you will
see this window only if you chose to configure or reconfigure SAN
switches.)
Set the SNMP Community String
The SNMP community string must be set to the same value on Clustered
File System and on the SAN switches managed by the cluster. The default
SNMP community string for Clustered File System is private. If you want
to use a custom community string instead, select Yes on the Specify
SNMP Community String window.
SAN Configuration
Enter hostnames of SAN switches to configure, separated by
whitespace.
< OK > <Cancel>
Specify SNMP Community String
Do you want to specify a community string to be used for
FibreChannel switch SNMP communication?
Note: All SAN switches must use the same community string.
Initial HP Clustered File System installations will use
the default community string as described in the installation
guide. (Anwer < No > to retain any currently configured
community string)
< Yes > < No >