HP StorageWorks Clustered File System 3.1.1 for Linux Installation Guide (May 2006)

Appendix B: Configure the Cluster from the Command Line 57
SAN Configuration. You will next be asked whether you want to
configure the SAN switches in Clustered File System. This step is optional
for Web Management Based Fencing configurations; however, if the
switches are configured the Management Console can display the switch
ports used by the SAN.
If the SAN switches have not previously been configured in Clustered
File System, you will see the following window.
If Clustered File System detects an existing SAN switch configuration, the
following window will appear. You can retain, remove, or modify the
existing configuration.
SAN Configuration
SAN switch configuration is optional for the fence module
selected
Do you want to configure SAN switches?
< Yes > < No >
SAN Configuration
SAN switch configuration is optional for the fence module
selected
A SAN switch configuration already exists for this server.
How do you want to proceed with SAN configuration?
< OK > <Cancel>
Retain Retain existing SAN switch configuration
Reconfigure Reconfigure SAN switches
Remove Remove existing SAN switch configuration