HP StorageWorks Clustered File System 3.1.1 for Linux Installation Guide (May 2006)

Appendix B: Configure the Cluster from the Command Line 52
CAUTION: You will next be asked whether all servers in the cluster are
from the same vendor. If you will be using IPMI as the fencing
method, you should be aware that only one IPMI session can
be active at a time. Clustered File System will fail to fence a
server if another IPMI session is already active on that server at
the time that the fencing attempt is made.
Remote Management Controller ID. On the Remote Management
Controller Configuration window, specify how Clustered File System
should identify the Remote Management Controller iLO associated with
each server. Use one of the following methods.
• Specify the common naming scheme that you are using for the Remote
Management Controllers (either a hostname suffix or an IP address
delta).
• Enter the hostname or IP address for the Remote Management
Controller associated with this cluster server.
Remote Management Controller Vendor
Select the vendor of the remote management controller for this
server
< OK > <Cancel>
Dell Dell ERA or DRAC III
HP Hewlett Packard ILO
IBM IBM MM, RSA, or RSA II
IPMI IPMI v1.5 (IPMI over LAN)