HP StorageWorks Clustered File System 3.1.1 for Linux Installation Guide (May 2006)

Chapter 4: Install HP Clustered File System 13
• mxconsole-3.1.1.<xxxx>.msi. The Management Console and mx utility
in Microsoft Windows format.
• pmxs-sles9-support-3.1.1-<xxxx>.<arch>.rpm. Clustered File System
support files for the supported SLES9 kernels. The files include
sample configuration files for building the kernel from source. There
are two versions of the Support RPM; one for 32-bit SLES9 and one for
64-bit. The Support RPMs are included only in the Clustered File
System distribution for SLES9.
• pmxs-quota-tools-3.1.1-<xxxx>.i386.rpm. Linux quota commands
modified for use on the PSFS filesystem.
• /Documentation. This directory contains the following Clustered File
System documentation. Most of the documents are in PDF format.
– HP StorageWorks Clustered File System for Linux administration guide.
– HP StorageWorks Clustered File System for Linux command reference.
– HP StorageWorks Clustered File System for Linux installation guide.
– HP StorageWorks Clustered File System File Serving Option for Linux
administration guide.
– HP StorageWorks Clustered File System for Linux Third Party Software
Initial Pre-Planning Steps
Complete the HP Pre-Planning Worksheet with your HP service expert.
This process is part of the HP installation service associated with this
product. Your HP representative provides this worksheet.
It is important to fill out the worksheet before you start configuring the
cluster nodes to ensure that you have the information required to
correctly configure your solution.
The following items are required for initial node setup:
• Network parameters (IP addresses, subnet masks, etc.)
– The two data NICs on each node
– The intra-node heartbeat NIC