HP StorageWorks Enterprise File Services WAN Accelerator 2.1 Installation and Configuration Guide (November 2005)

HP STORAGEWORKS EFS WAN ACCELERATOR INSTALLATION AND CONFIGURATION GUIDE 43

2 - INSTALLING AND

ONFIGURING THE HP EFS

Configuring the

Client-Side HP

EFS WAN

Accelerator

In an out-of-path configuration, you configure the client-side, HP EFS WAN

Accelerator in the same way as an in-path configuration. For optimization to

occur, you must define a fixed-target rule on the client-side HP EFS WAN

Accelerator that points to the out-of-path, server-side HP EFS WAN

Accelerator. You can define fixed-target rules using the Management Console

or the CLI.

For detailed information about the Management Console, see the HP Enterprise

File Services WAN Accelerator Management Console User Guide.

For detailed information about the CLI, see the HP Enterprise File Services WAN

Accelerator Command-Line Interface Reference Manual.

To configure the

client-side HP EFS

WAN Accelerator

1. Follow the procedures for an in-path configuration. For details, see

“Configuring In-Path HP EFS WAN Accelerators” on page 32.

2. Connect to the Management Console. For details, see “Connecting to the

Management Console” on page 37.

3. Navigate to the Setup: Optimization Service - In-Path Rules page.

Figure 2-8. Setup: Optimization Service - In-Path Rules Page

4. Under Add New Rule, select Fixed-Target from the Type drop-down list.

5. Under Targets, type the IP address and port number for the HP EFS WAN

Accelerator that is the peer in the Target IP and Port text boxes.