HP StorageWorks Enterprise File Services WAN Accelerator 2.1 Command Line Interface Reference Guide (November 2005)
HP STORAGEWORKS EFS WAN ACCELERATOR COMMAND-LINE INTERFACE REFERENCE MANUAL 25
3 - ENABLE-MODE COMMANDS
CHAPTER 3 Enable-Mode Commands
In This Chapter This chapter is a reference for enable-mode commands. Enable-mode commands are
commands that display process information.
To enter enable-mode 1. Connect to the CLI. For detailed information, see “Connecting to the CLI” on
page 17.
2. To enter enable-mode, at the system prompt enter:
host > enable
host #
To enter enable-mode, enter enable. For information about the enable command, see
“enable” on page 21.
To exit enable-mode, enter exit. For information about the exit command, see “exit”
on page 22.
This chapter describes the following enable-mode commands:
“configure terminal,” next
“debug generate dump” on page 28
“disable” on page 28
“file debug-dump” on page 28
“file stats” on page 28
“reload” on page 29
“restart” on page 29
“show aaa” on page 30
“show arp” on page 30
“show bootvar” on page 30
“show cli” on page 31
“show clock” on page 31
“show configuration” on page 31
“show configuration files” on page 32