HP StorageWorks Enterprise File Services WAN Accelerator 2.1 Command Line Interface Reference Guide (November 2005)

HP STORAGEWORKS EFS WAN ACCELERATOR COMMAND-LINE INTERFACE REFERENCE MANUAL 149
4 - CONFIGURATION-MODE
C
OMMANDS
To enable failover support with WCCP groups, define the service group weight to be
0 on the backup HP EFS WAN Accelerator. If one HP EFS WAN Accelerator has a
weight 0, but another one has a non-zero weight, the HP EFS WAN Accelerator with
weight 0 does not receive any redirected traffic. If all the HP EFS WAN Accelerators
have a weight 0, the traffic is redirected equally among them.
If the source or destination flags are set, the router redirects only the TCP traffic that
matches the source or destination ports specified.
For detailed information about configuring WCCP, see the HP StorageWorks
Enterprise File Services WAN Accelerator Deployment Guide.
Syntax wccp service group {<service ID> router <ip_address>} |
[flags <comma_separated_list> |
priority <priority_number> |
ports <comma separated list of up to 7 ports> |
password <string> |
weight <value> |
encap_scheme <string>]
Parameters
service group
<service ID>
Specifies the service group identification number (ID) (from 0 to
255). The service group ID is the number that is set on the router. A
value of 0 specifies the standard http service group.
router
<ip_address>
The router IP is a multicast group IP address or a unicast router IP
address. A total of 32 routers can be specified.