HP StorageWorks Enterprise File Services WAN Accelerator 2.1 Command Line Interface Reference Guide (November 2005)

HP STORAGEWORKS EFS WAN ACCELERATOR COMMAND-LINE INTERFACE REFERENCE MANUAL 135
4 - CONFIGURATION-MODE
C
OMMANDS
service neural-framing stats enable
Description Enables neural-framing statistics. By default statistics are disabled. Neural framing
enables the HP EFS WAN Accelerator to select the optimal packet framing
boundaries for Scalable Data Referencing (SDR). SDR encoding provides the best
optimization results when the largest buffer is available before a flush is performed.
Neural framing creates a set of heuristics to intelligently determine the optimal
moment to flush TCP buffers. The HP EFS WAN Accelerator continuously evaluates
these heuristics and uses the optimal heuristic to maximize the amount of buffered data
transmitted in each flush, while minimizing the amount of idle time that the data sits
in the buffer. The no command option disables neural-framing statistics.
You must set the neural framing mode (algorithm) for your in-path rules on which you
want to apply neural framing.
Syntax service neural-framing stats enable
Parameters None
Example
minna (config) # service neural-framing stats enable
minna (config) #
service port
Description Sets a new service port to add for multiple service ports. Service ports are the ports
used for inner connection between HP EFS WAN Accelerators.
You can configure multiple service ports on the server-side of the network for multiple
QoS mappings. You define a new service port and then map CIFS ports to that port, so
that QoS configuration settings that are on the router are applied to that service port.
The no command option disables the service port.
Syntax service port <port>
Parameters
Example
minna (config) # service port 7800
minna (config) #
snmp-server community
Description Enables an SNMP server community. The no command option disables an SNMP
server community.
Syntax snmp-server community <name>
<port> Specifies the new port to add. The default service ports are 7800 and 7810.