HP StorageWorks Enterprise File Services WAN Accelerator 2.1 Command Line Interface Reference Guide (November 2005)

132 4 - CONFIGURATION-MODE COMMANDS
Parameters
Example
minna (config) # radius-server timeout 30
minna (config) #
segstore receive port
Description Receives the data store from another HP EFS WAN Accelerator. The failover HP EFS
WAN Accelerator must be the same model. You cannot preload a data store on a non-
failover HP EFS WAN Accelerator.
Syntax segstore receive port <port>
Parameters
Example
minna (config) # segstore receive port 20
minna (config) #
segstore send addr
Description Sends the data store to another HP EFS WAN Accelerator. The other HP EFS WAN
Accelerator must be the same model. You cannot preload a data store on a non-
failover HP EFS WAN Accelerator.
Syntax segstore send addr <addr> [port <port>]
Parameters
Example
minna (config) # segstore send addr 10.10.10.1
minna (config) #
service connection pooling
Description Enables a pool of connections to a peer HP EFS WAN Accelerator. Connection
pooling enables you to save an extra round-trip for the initial connection setup.
Connection pooling is useful for protocols which open a number of short lived
connections such as HyperText Transport Protocol (HTTP). The no command option
disables connection pooling.
<seconds> Sets the timeout for retransmitting a request to any RADIUS
server. The range is 1-60. The default value is 3.
<port> Specifies the port number.
<addr> Specifies the IP address.
port <port> Specifies the port number.