HP ProLiant DL100 G2 Data Protection Storage Server installation guide (June 2006)

7. On the Internet Optio n s dialog box, click OK to finish.
To co nnect the storage ser ver to a network u sing the Remote Browser
method
1. On the remote client machine, open Internet Explorer and
enter https:// and the serial number of the storage server
followed by a hyphen (-), and then:3202. For example,
https://D4059ABC3433-:3202. Press Enter.
NOTE:
If you a re able to determine the IP address from your DHCP
server, you can substitute the IP address for the serial
number and hyphen. For example: 192.100.0.1:3202.
2. Click OK on the Security Alert prompt.
3. Log in to the HP ProLiant Data Protection Storage Server Management
console with the default user name administrator and the
password hpinvent. The HP ProLiant Data Protection Storage
Server Management Console and the Rapid Startup Wizard start
automatically.
NOTE:
You can change the administrator name and password
when you configure the server using the Rapid Startup
Wiz ard on page 34.
4. To complete network configura tion using the Rapid Startup Wizard,
see Configuring the server on the network on page 31.
IMPORTANT:
If you are using the Remote Browser method to access the HP Data
Prote
ction Storage Server Management console and Rapid Startup
Wizard, always close the remote session before closing your Internet
browser. Closing the Internet browser does not close the re mote session.
Failure to close your rem
ote session impacts the limited number of remote
sessions allowed on the storage server at any g
iven time.
Using the Remote Desktop method
To co nnect the storage server to a n etwork using the Remote Desktop
method
28
Accessing the HP Data Protection Storage Server Management
console