HP Device Manager 4.6 - Imaging Guide

Non-
cached
t510 4 22 24 31
t610 16 16 19 23
t5570 2 18 26 26
t5740 4 16 20 24
t5400 2 18 21 28
6360t 4 16 21 23
Table 3. HP ThinPro imaging task performance
Operating
system
Connection
type
Mode Device
model
Disk
size
(GB)
File
system
size
(GB)
Image
clone-zero
duration
(minutes)
Image
clone-clone
duration
(minutes)
Image
deploy-
deploy
duration
(minutes)
Image
deploy-
resize
duration
(minutes)
HP ThinPro Wired Non-
cached
t610 4 1 0.33 3 4 1
4 4 2 4 15 0.03
16 1 0.13 2.5 2.5 13.5
16 16 28.5 8.5 13 0.03
Known issues
When deploying an image using PXE, if a device is shut down and not set to Network boot first, the device receives the
reboot task circularly.
Workaround:
1. Go into the BIOS and enable Network boot first.
2. Cancel the task from the HPDM Console.
For WES 7E, WES 7P, and WES 2009, if the source thin client was joined to a domain prior to a Capture Image task, the
domain membership is lost after cloning the image. HP recommends removing the source device from any domain before
a Capture Image task.
The group policy that controls the domain password complexity affects local user accounts, resulting in a requirement to
change the password to meet stricter criteria.
HPDM does not support deploying a WES 7P image downloaded from HP.com.
Workaround:
1. Deploy this image to a device using a local image tool, such as HP ThinState or Ghost by Symantec.
2. Capture the image from this device via HPDM.
3. Deploy the newly captured image to other devices.
HPDM does not support deploying an image file downloaded from HP.com to a thin client that uses a wireless network.
Workaround:
1. Deploy this image to a device using a local image tool, such as HP ThinState or Ghost by Symantec.
or
Configure the device to use a wired network, and then deploy the image to this device via HPDM.
1. Configure the wireless network settings after deploying the image.
2. Capture the image from this device via HPDM.
3. Deploy the newly captured image to other devices that use a wireless network.
The resize partition operation cannot be done when deploying image to a t410.
The Shared Folder protocol is not supported when capturing an image from or deploying an image to a t410.
33