HP Device Manager 4.6 Administrator Guide

Table A-5 Operation templates (continued)
Template Description
_Reverse Shadow Device This template causes the HPDM Agent on a targeted device to connect to the VNC
viewer bundled with the HPDM Console by SSL tunnel. This template is not available
for the HPCE thin clients.
_Send Message This template sends a customized message to targeted devices. This template is not
available for HP ThinPro thin clients.
_Shadow Device This template causes VNC viewer bundled with the HPDM Console to connect to the
VNC service on a targeted device by SSL tunnel.
_Shutdown Device This template shuts down the targeted devices. A warning message will be displayed
on the devices’ screen for 15 seconds before the reboot actually takes place.
_Start Resource Monitor This template starts the Resource Monitor for the target device. This template can
only be sent to a single device at a time and is not available for HP ThinPro thin
clients.
When this template is sent to a device successfully, a Resource Monitor dialog will
pop up. You can monitor Process, Performance, and Network Disk information.
_Wake Up Device This template will cause the HPDM Gateway associated with the targeted devices to
send them a Wake On LAN message. The Wake device works not only for devices in
the same subnet with HPDM Gateway, but also for devices that are not in the same
subnet of HPDM Gateway, if the subnet has at least one online HPDM Agent. We can
wake up devices behind NAT, if the subnet has at least one online HPDM Agent.
During timeout, HPDM Gateway reports the unfinished part as failure.
Settings
Table A-6 Setting templates
Template Description
_Apply Settings This template enables you to create a set of custom settings and deploy them to one
or more devices.
_Clone Settings This template enables you to copy a selection of custom settings from one device and
deploy them to other devices.
_Deploy Profile This template is used to configure a profile and deploy it to thin clients running HP
Smart Zero Core.
_Enroll Certificate With SCEP This template enables you to enroll certificates with SCEP on normal thin clients.
_Hostname and IP This template enables you to change the hostname and IP address of one or more
devices. There are two options:
●
Modify specified devices—Only functions when you drag it to one or more target
devices.
●
Set with pattern—Changes hostname and IP with the same pattern.
_Set Domain The _Set Domain template allows devices to join a domain or a workgroup.
_Set Password This template enables you to set a password for one or more users on one or more
devices. You can check hide password check box to hide the password, or clear the
check box it to show the password.
NOTE: This template is not available for thin clients running HP Smart Zero Core.
Settings 83