HP Device Manager 4.6 Administrator Guide
3. Enter MC Address in the Name field, set the Data type to String, set Code to 1, and then click
OK.
4. Set the Value of the MC Address to the IP address of the HPDM Gateway, and then click OK.
To enable a vendor class option:
1. Select the Scope Options of the Scope that the PCoIP zero clients are in.
2. Right-click to display the menu, and then select Configure Options to display the Scope Options
dialog.
3. Select the Advanced tab.
4. Set the vendor class to PCoIP Endpoint, enable the MC Address option, and then click OK.
5. Restart the PCoIP zero clients. They will report to HPDM automatically.
To troubleshoot this method:
1. Verify the network information, including the IPv4 address and domains, of the PCoIP zero
clients.
2. The PCoIP zero clients have an embedded diagnostic tool. Use it to ping the HPDM Gateway
address in the MC Address.
Searching for devices
HPDM can search a range of IP addresses for HPDM Agents and HPDM Gateways. There are two
methods: Walking With IP Range and Walking With IP List. Each of these methods begin in the same
manner:
1. In the HPDM Console, click the HPDM Gateway tab.
2. Right-click the desired HPDM Gateway and select Discover Device in the menu.
3. Select the device type (normal thin client or PCoIP zero client).
4. Proceed to
Using the Walking With IP Range method on page 20 or Using the Walking With IP
List method on page 21, depending on the method you wish to use.
Using the Walking With IP Range method
To search using the Walking With IP Range method:
1. Select Walking With IP Range, and then click Next.
2. You can specify the range of IP addresses to search by using either an IP scope or by manually
specifying an IP range. An IP scope is a range of IP addresses that you have built and saved for
future scans.
To search using an IP scope:
▲
Select the Use Preset IP Scope checkbox, select an IP Search Scope, and then click OK.
To search using a manually-specified IP range:
▲
Deselect the Use Preset IP Scope checkbox, enter a Starting IP Address and an Ending IP
Address, and then click OK.
You can check the progress of the discovery by displaying the HPDM Gateways tab and
selecting the name of the HPDM Gateway. The discovery progress will be displayed in the tasks
pane at the bottom of the HPDM Console window.
20 Chapter 3 Device discovery