HP DesignJet 700/750C Plus Plotters Quick Reference Guide - C4705-90041
23
23
I/O setup Modular
MIO
(option)
RS-232-C Config=
Factory
Config A
Config B
38400, 19200, 9600,
Define config Config A Baudrate=
4800, 2400, 1200
Config B
Factory Parity=
None, Even, Odd
I/O Timeout=
0.5, 1, 2, ...30min
Device setup Sharp Lines=*
Auto, On, Off,
Skew tolerance=
Off, On
Key:
represents pressing ENTER
Cartridge check=
On, Off Defaults are indicated by
Yellow Shading = Short menu
Lightness=
Dark, Normal, Light
* Not on DesignJet 700
Lang=
Automatic (with
PostScript option)
PostScript
(option)
Scale=
100%, 129%, 141%, 200%, 210%, 258%, 282%,
HP-GL/2 352%, 400%, 419%
7586, HP–GL/2 Terminator=
Normal, Special
Drying time=
None, Less, Normal, More
Continued.....
Localization Note. This table contains the front-panel strings used in the front-panel menus. (All languages except KCT) Use the translations
of these supplied for your language. (KCT only) Do not translate table entries. (All) You can adjust column widths slightly and join two
horizontally adjacent cells if necessary ( already done on in some places). A one–point reduction of the font size can be used if no alternative.
Very similar to 750c UG English except for Sharp lines (added) and Lightness (added).
This is the yellow on page 23 (seq: 23)
This is the cyan on page 23 (seq: 23)